New Arrivals/Restock

Spa Pressure Switch Hot Spot and Solana Compatible with Most Watkins Spas 71586/3903

flash sale iconLimited Time Sale
Until the end
04
24
20

US$28.06 cheaper than the new price!!

Free shipping for purchases over $99 ( Details )
Free cash-on-delivery fees for purchases over $99
Please note that the sales price and tax displayed may differ between online and in-store. Also, the product may be out of stock in-store.
Used  US$18.70
quantity

Product details

Management number 216047024 Release Date 2026/04/19 List Price US$18.70 Model Number 216047024
Category

Watkins Spa Pressure Switch Hot Spot & Solana 71586 / 3903. This pressure switch (looks like a radiator thermostat) is a safety device that screws into the heater that will shut down the heater if a "low water flow" condition occurs. It is used on all 1999-2005 Hot Spot spa models as well as all 2000-2002 Solana X, 2003-2005 Solana RX, SX & TX spa models. PRESSURE SWITCH REMOVAL 1. Disconnect power to the spa. 2. Remove the front access panel. 3. Drain the spa. 4. Open the drain valve to bleed the water out of the plumbing. 5. Open the control box lid. 6. Disconnect the pressure switch connection wires from the pressure switch. 7. Unscrew the pressure switch from the heater and remove any residual Teflon tape from the threads of the heater body where the pressure switch was connected. RE-INSTALLATION Reverse the removal procedure to install the pressure switch in the control box. NOTE: Wrap one piece of Teflon tape (in the opposite direction of the threads) three times around the pressure switch threads before installation. When screwing the new pressure switch into the heater, DO NOT use pliers, grasp the body of the pressure switch and hand tighten only. After you are finished with the installation, switch the jet pump to high speed and check the pressure switch for leaks. 3902 is also a replacement

  • High Quality thats made to last!!
UPC 680642882648
Terminal Screw
Brand Name Hot Tub Classic parts
Unit Count 1.0 Count
Switch Type Pressure Switch
Circuit Type 1-way
Contact Type Normally Open
Manufacturer Hot Tub Classic parts
Actuator Type Screw
Material Type Brass, Copper
Mounting Type Panel Mount
Connector Type Screws
Control Method Touch
Operation Mode automatic
Contact Material Copper, Brass
Connectivity Protocol X-10
International Protection Rating IP54

Correction of product information

If you notice any omissions or errors in the product information on this page, please use the correction request form below.

Correction Request Form

Product Review

You must be logged in to post a review